Suzuki Ignis Service Manual page 3772

1
G47-8 G47-5
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-17
Rear wiper auto stop circuit
1) Check that wiper motor operates with the wiper switch at
rear position.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to "Disabling air bag system"
in section 10B.
4) Pull out rear wiper intermittent timer (1).
5) Disconnect coupler, and connect negative cable at battery.
6) Check that the voltage and resistance between the following
terminals are as specification.
Terminals
G47-8 and
When ignition switch is in OFF.
ground
When wiper blades are stopped
at windshield base.
Turn ignition switch to ON.
G47-5 and
Turn rear wiper switch to ON
ground
then to OFF so that wiper
blades stop at the position
except starting point.
If check result is not satisfactory, repair wiring and check wiper
motor.
7) Check the continuity between terminals "a" and "b" of inter-
mittent timer. If continuity is not obtained, replace intermit-
tent timer and recheck.
8) After intermittent timer lead wire coupler is connected and
intermittent timer is installed, enable air bag system. Refer to
"Enabling air bag system" in Section 10B.
Condition Specification
Continuity
Continuity
10 – 15 V