Table of Contents
Advertisement
8B-16 LIGHTING SYSTEM
Headlight Aiming Adjustment With Screen
NOTE:
• Unless otherwise obligated by local regulations, adjust
headlight aiming according to the following procedure.
• When inspecting and adjusting headlight with leveling
system, make sure to set the leveling switch to "0"
position with ignition switch turned to ON.
1) Make sure the following items.
• Place vehicle on a flat surface in front of blank wall (screen)
(1) ahead of headlight surface.
Distance between screen and headlight
"a": 10 m (32.8 ft.)
• Adjust air pressure of all tires to the specified value respec-
tively.
• Bounce vehicle body up and down by hand to stabilize sus-
pension.
• Carry out aiming with a driver aboard.
Driver's weight
75 kg (165 lb)
2) Check to see if not spot (5) (high intensity zone) of each low
beam axis falls as shown in the figure.
Hot spot specification
"H": Approx. 130 mm (5.15 in.)
3) Align headlight aiming to specification by adjusting aiming
gear if it is not set properly.
2. Cut line (bounding line)
3. Heading assembly
4. Aiming (for right/left adjustment)
5. Aiming (headlight leveling actuator) (for up/down adjustment)
X-X: Horizontal center line of headlights bulb
A-A: Vertical center line of left headlight bulb
B-B: Vertical center line of right headlight bulb
[A]: LH headlight
[B]: RH headlight
[C]: RH steering vehicle shown
[D]: LH steering vehicle shown
Advertisement
Table of Contents
