Suzuki Ignis Service Manual page 3769

8D-14 WINDOWS, MIRRORS, SECURITY AND LOCKS
1
G46-8
G46-5
Wiper Circuit Inspection
Front wiper auto stop circuit
1) Check that wiper motor operates with the wiper switch at low
position.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to "Disabling air bag system"
in Section 10B.
4) Pull out front wiper intermittent timer (1).
5) Disconnect coupler, and connect negative cable at battery.
6) Check that the voltage and resistance between the following
terminals are as specification.
Terminals
G46-8 and
When ignition switch is in OFF.
ground
When wiper blades are stopped
at windshield base.
Turn ignition switch to ON.
G46-5 and
Turn front wiper switch to ON
ground
then to OFF so that wiper
blades stop at the position
except starting/returning point.
If check result is not satisfactory, repair wiring and check wiper
motor.
7) Check the continuity between terminals "a" and "b" of inter-
mittent timer.
If continuity is not obtained, replace intermittent timer and
recheck.
8) After intermittent timer lead wire coupler is connected and
intermittent timer is installed, enable air bag system. Refer to
"Enabling air bag system" in Section 10B.
Condition Specification
Continuity
Continuity
10 – 15 V