Table of Contents
Advertisement
1, (a)
1, (a)
1, (a)
4) Support door panel (1) using a jack (2) with a piece of wood
placed (4) between jack (2) and panel (1) as shown.
3. Rags
5) Remove door assembly (1) by loosening hinge mounting
bolts (2).
INSTALLATION
Reverse removal procedure to install door assembly noting the
following instructions.
• When replacing door, coat replacement door inside with wax
for proper anti-corrosion treatment.
Refer to "Anti-Corrosion Compound Application Area" in this
section.
• Apply sealant to contact face "A" of hinge (1).
"A": Sealant 99000-31110
• Apply grease to rotating part "B" of hinge (1).
"B": Lithium grease 99000-25010
• Tighten hinge bolt (1) to specified torque.
Tightening torque
Door hinge mounting bolt
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
BODY SERVICE 9-23
Advertisement
Table of Contents
