Suzuki Ignis Service Manual page 3774

Rear washer linked circuit
1) Check that wiper motor operates with the wiper switch at
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to "Disabling air bag system"
4) Pull out rear wiper intermittent timer (1).
5) Disconnect coupler, and connect negative cable at battery.
6) Check that the voltage and resistance between the following
G47-6
If check result is not satisfactory, repair wiring and check wiper
G47-2
motor.
G47-8 G47-4
7) After intermittent timer lead wire coupler is connected and
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-19
rear position, and return to original position with the wiper
switch turned OFF.
in Section 10B.
terminals are as specification.
Terminals
When ignition switch is in OFF.
G47-2 and
ground When ignition switch is in ON.
G47-6 and
When ignition switch is in OFF.
ground
G47-8 and
When ignition switch is in OFF.
ground
When ignition switch is in ON
and rear washer switch is in
OFF.
G47-4 and
ground
When ignition switch is in ON
and rear washer switch is in
ON.
NOTE:
When rear washer switch is in ON position for one sec-
ond or more and then turned OFF, the rear wiper motor
operates for approximately 5 seconds after rear washer
switch is turned OFF.
intermittent timer is installed, enable air bag system. Refer to
"Enabling air bag system" in Section 10B.
Condition Specification
0 V
10 – 15 V
Continuity
Continuity
0 V
10 – 15 V