Suzuki Ignis Service Manual page 3750

2
40
Fuel Gauge Inspection
NOTE:
Make sure that all related connector terminals are in
good contact condition before combination meter
inspection.
1) Remove combination meter referring to "Combination Meter
Removal and Installation" in this section.
2) Connect combination meter connectors to combination
meter.
3) Short "YEL/RED" wire terminal of combination meter con-
nector to body ground as shown.
4) Turn ignition switch to ON position, and check that meter
pointer (1) of fuel level gauge indicates "E" and low fuel
warning light turns on.
1
5) Turn ignition switch to OFF position.
6) Short "YEL/RED" wire terminal of combination meter con-
nector to body ground through a resister (40Ω) (2) as shown.
7) Turn ignition switch to ON position, and check that meter
pointer (1) of fuel level gauge indicates "F".
1
If check result is not satisfied, replace combination meter.
Fuel Level Sensor (Gauge Unit) Removal and
Installation
Remove fuel pump assembly referring to "Fuel Pump Assembly
Removal and Installation" in Section 6C.
INSTRUMENTATION/DRIVER INFORMATION 8C-9