Suzuki Ignis Service Manual page 3737

8B-18 LIGHTING SYSTEM
Front Fog Light Aiming Adjustment With
Screen
Basic aiming
NOTE:
• Unless otherwise obligated by local regulations, adjust
front fog light aiming according to the following proce-
dure.
• An example in case that the light-to-wall distance 10 m
is shown in the illustration. The beam descending dis-
tance "H" is calculated when "a" is 10 m with the spec-
ification angle "b" (1.2°).
1) Make sure the following items.
• Place vehicle on a flat surface in front of blank wall (screen)
(1) ahead of front fog light surface.
Distance between screen and front fog light
"a": 10m (32.8ft.)
• Adjust air pressure of all tired to the specified value respec-
tively.
• Bounce vehicle body up and down by hand to stabilize sus-
pension.
• Carry out aiming with a driver aboard.
Driver's weight
75 kg (165 lb)
2) Check to see if hot spot (high intensity zone) of each front
fog light axis falls as shown in the figure.
Hot spot specification
Angle "b": 1.2° (Specification)
Calculated distance "H": Approx. 210 mm (8.27 in.)
3) If it is not set properly, align front fog light to specification by
rotating aiming gear.
2. Front fog light assembly
3. Aiming gear
4. Aiming (for up adjustment)
5. Aiming (for down adjustment)
6. Hot spot
7. Bounding line
X-X: Horizontal center line of front fog light bulb
A-A: Vertical center line of left front fog light bulb
B-B: Vertical center line of right front fog light bulb
[A]: Gear adjuster type
[B]: Screw adjuster type