Table of Contents
Advertisement
2,(a) 1,(a)
(a)
2
1
(c)
1
Installation
1) Install new gasket to cylinder head.
Then install exhaust manifold.
Tighten manifold bolts (1) and nuts (2) to specified torque.
Tightening torque
Exhaust manifold bolts and nuts
(a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
NOTE:
The figure on the left varies with specification.
2) Install new seal ring and connect exhaust No.1 pipe (1) to
exhaust manifold.
Tighten pipe fasteners to specified torque.
Tightening torque
(b)
Exhaust No.1 pipe bolts (a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
3) Install exhaust manifold stiffener (2).
Tighten exhaust manifold stiffener bolts to specified torque.
2
Tightening torque
Exhaust manifold stiffener bolts
(b) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
4) Install new seal ring and connect exhaust No.1 pipe (1) to
exhaust No.2 pipe.
Tighten pipe fasteners to specified torque.
Tightening torque
Exhaust No.2 pipe bolts (c) : 43 N·m (4.3 kg-m, 31.5 lb-ft)
5) Connect heated oxygen sensor coupler (1) and fit coupler to
bracket securely.
6) Install A/C condenser to vehicle body for equipped with A/C.
7) Install radiator referring to "Radiator Removal and Installa-
tion" in Section 6B for equipped with A/C.
8) Install front bumper with front grille by referring to "Front
Bumper and Rear Bumper Removal and Installation" in Sec-
tion 9.
9) Connect negative cable to battery.
10) Check exhaust system for exhaust gas leakage.
ENGINE MECHANICAL (M13 ENGINE) 6A1-25
Advertisement
Table of Contents
