Table of Contents
Advertisement
8D-26 WINDOWS, MIRRORS, SECURITY AND LOCKS
8
7
6
5
18
17
16
15
14
Power door lock system circuit check
Terminal
Wire
G11-6
WHT
G11-9
WHT/BLU Main power supply
G11-11
WHT/BLK Key remainder circuit
G11-12
RED/BLK Ignition switch circuit
G11-13
RED/BLU
G11-14
WHT/RED
G11-15
BLK/RED Door switch circuit
G11-17
BLK
1
4
3
2
1
13
12
11
10
9
V
Circuit
Power door lock switch
circuit
Driver side key cylinder
circuit (UNLOCK signal)
Driver side key cylinder
circuit (LOCK signal)
Ground
5) Check that the voltage and resistance between the following
terminals and body ground are specifications under each
conditions.
If check result is OK, replace door lock controller. If check
result is not as specified, repair circuit.
1. Power door lock controller coupler "G11" viewed from harness side
Specification
Continuity
No continuity
10 – 14 V
10 – 14 V
0 – 1 V
10 – 14 V
0 – 1 V
Continuity
No continuity
Continuity
No continuity
0 – 1 V
10 – 14 V
1 Ω or less
Condition
Power door lock switch is in pushed
position.
Power door lock switch is in free posi-
tion.
–
Ignition switch in ACC position.
Ignition key is not in ignition.
Ignition switch is in ON position.
Ignition switch is in OFF position.
Driver side key cylinder is in UNLOCK
position.
Except the above-mentioned condition.
Driver side key cylinder is in LOCK
position.
Except the above-mentioned condition.
Driver side, passenger side, rear driver
side, rear passenger side or rear end
door is open.
All doors are close.
–
Advertisement
Table of Contents
