Suzuki Ignis Service Manual page 3738

1
2
2
1
Turn Signal Switch Removal and Installation
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Remove dash side trim (1), steering column hole cover (2)
and steering column covers (3).
3
3) Remove turn signal switch (1) while releasing the locks.
4) Disconnect turn signal switch connector (2).
INSTALLATION
Reverse removal procedure for installation.
Turn Signal Switch Inspection
Check the continuity at each switch position. If any correct conti-
nuity is not obtained, replace turn signal switch.
Turn signal switch specification
Switch Position
Terminal
TL TB
L
N
R
LIGHTING SYSTEM 8B-19
TR