Suzuki Ignis Service Manual page 3818

1
2
Immobilizer Control Module Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove driver air bag (inflator) module from steering wheel
referring to "Driver Air Bag (Inflator) Module Removal and
Installation".
3) Remove steering wheel referring to "Steering Wheel
Removal and Installation".
4) Remove steering column upper cover, steering column lower
cover, contact coil and combination switch assembly refer-
ring to "Contact Coil Cable Assembly Removal and Installa-
tion".
5) Remove key cylinder referring to "Steering Column Removal
and Installation".
6) Remove immobilizer control module (1) from steering col-
umn.
7) If immobilizer control module is equipped with metal cover
(2), remove metal cover. If not, go to the next step.
8) Disconnect connector from immobilizer control module.
Installation
Reverse removal procedure for installation.
NOTE:
After replacing Immobilizer Control Module, be sure to
register Transponder code and ECM/Immobilizer Control
Module code in Immobilizer Control Module and ECM/
Immobilizer Control Module code in ECM by performing
procedure described in "Procedure After Immobilizer
Control Module Replacement" in this section.
IMMOBILIZER CONTROL SYSTEM 8G-21