Table of Contents
Advertisement
10-6 RESTRAINT SYSTEM
Front Seat Belt Removal and Installation
REMOVAL
WARNING:
• Never attempt to disassemble or repair the seat belt
pretensioner (retractor assembly). If any abnormality is
found, be sure to replace it with new one as an assem-
bly.
• Be sure to read "Service Precautions" in Section 10B,
before starting to work and observe every precaution
during work. Neglecting them may result in personal
injury or unactivation of the seat belt pretensioner
when necessary.
1) Disconnect negative battery cable at battery.
2) Disable air bag system. Refer to "Disabling air bag system"
in Section 10B.
3) Remove center pillar lower trim.
4) Disconnect Yellow connector for seat belt pretensioner.
a) Release locking of lock pin.
b) After unlocked, disconnect connector from seat belt preten-
sioner.
5) Remove front seat belts from the vehicle.
INSTALLATION
Install in reverse order of removal, noting the following.
• Seat belt anchor bolts should have an unified fine thread (7/
16-20 UNF). Under no circumstances should any different
sized or metric screw threads be used.
• Be sure to tighten bolts and screw in order ("A" – "D") as
shown.
• Tighten bolts and screw to specified torque referring to
"Front Seat Belt Components" in this section.
• Confirm that seat belt is not twisted when installing seat belt.
Advertisement
Table of Contents
