Table of Contents
Advertisement
5) Remove air bag (inflator) module(s) or seat belt preten-
sioner(s) from vehicle referring to "Driver Air Bag (Inflator)
Module Removal and Installation" in Section 3C, "Passenger
Air Bag (Inflator) Module Removal and Installation" in this
section, "Front Seat Belt Removal and Installation" in Sec-
tion 10 and "Front Seat Removal and Installation" in Section
9.
WARNING:
• For handing and storage of live air bag (inflator) mod-
ule, select place where ambient temperature below
65°C (150°F), without high humidity and away from
electric noise.
• Always carry live air bag (inflator) module with trim
cover away from you.
• When storing live air bag (inflator) module or when
leaving live air bag (inflator) module unattended on
bench or other surface, always face trim cover up and
away from surface. Front seat back with live air bag
(inflator) module must be placed with its frontal seat
cover facing up. This is necessary so that free space is
provided to allow air bag (inflator) module to expand in
the unlikely event of accidental deployment.
Failure to follow procedures may result in personal
injury.
WARNING:
• For handling and storage of a live seat belt preten-
sioner, select a place where the ambient temperature
below 65°C (150°F), without high humidity and away
from electric noise.
• Never carry the seat belt pretensioner by webbing.
• When placing live seat belt pretensioner on workbench
or other surface, be sure not to put something on seat
belt pretensioner.
Otherwise, personal injury may result.
6) Set air bag (inflator) module or seat belt pretensioner as fol-
lows.
• For driver air bag (inflator) module
i) Clear space (3) on ground about 185 cm (6 ft) in diameter
where driver air bag (inflator) module (1) for deployment.
Paved, outdoor location where there is no activity is pre-
ferred. If outdoor location is not available, space on shop
floor where there is no activity and provide sufficient venti-
lation. Ensure no loose or flammable objects are within
deployment area.
ii) Place driver air bag (inflator) module (1) with its vinyl trim
cover facing up (2) on ground in step i).
AIR BAG SYSTEM 10B-81
Advertisement
Table of Contents
