Suzuki Ignis Service Manual page 3702

(b)
(a), "A"
2
Remounting
Reverse removal procedure for installation, noting the following.
• Clean mating surfaces of axle housing (1) and differential
carrier and apply sealant to housing side.
"A": Sealant 99000-31110
• Apply sealant to carrier bolts and tighten carrier bolts to
specified torque.
"A": Sealant 99000-31110
Tightening torque
Differential carrier bolts
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
• Install propeller shaft to companion flange aligning match
marks (2) and tighten propeller shaft bolts to specified
torque.
Tightening torque
Propeller shaft bolts
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
• For installation of rear axle shaft, refer to "Rear Axle Shaft
and Wheel Bearing Removal and Installation (for 4WD
Model)" in Section 3E.
• For installation of rear brake drum, refer to "Brake Drum
Removal and Installation (for 4WD Model)" in Section 5C.
• Refill differential housing with new specified oil referring to
"Rear Differential Gear Oil Change" in this section for refill.
• Make sure to purge air out of brake circuit referring to "Air
Bleeding of Brake System" in Section 5. Then, ensure that
joint seam of pipe is free from oil leak.
REAR DIFFERENTIAL 7F-7