Table of Contents
Advertisement
1
2
1
2
1
7) Remove door trim bracket (1).
8) Remove door sealing cover (2).
9) Remove door mirror.
Refer to "Door Mirror Removal and Installation" in this sec-
tion.
10) Remove outer weather-strip (1). Do not deform it when
removal.
Lower window all the way down. Then, pry off outer weather-
strip using a tape-wrapped putty knife.
11) Remove bottom channel attaching screws (1).
12) Remove door glass (2) while tilting it as shown in figure.
2
INSTALLATION
Reverse removal procedure to install door glass noting the follow-
ing instructions.
• Fit bottom channel (1) on glass bottom end as shown in fig-
ure.
Glass fitted position of bottom channel
"a": 90.8 – 93.8 mm (3.57 – 3.69 in.)
• Tighten bottom channel attaching screws. Tighten rear
screw first, and then tighten front screw.
BODY SERVICE 9-5
Advertisement
Table of Contents
