Suzuki Ignis Service Manual page 3920

[A]: Fig. for Step 3
1. SDM connector "L21"
2. "G22" connector (22-pin) for combination meter
Special tool
(A): 09932-76010
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Table C: "AIR BAG" Warning Lamp Flashes
Step
1 1) With ignition switch OFF, disconnect SDM
connector "L21".
2) Check "L21-8" terminal of SDM.
Is it shorted to ground terminal or harness.
Special tool
(A): 09932-76010
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
[A]
1
"L21-30"
(A)
Action
"G22-2" 2
(A)
Yes
Clean up terminal.
AIR BAG SYSTEM 10B-19
No
Substitute a known-good
SDM and recheck.