Suzuki Ignis Service Manual page 3983

10B-82 AIR BAG SYSTEM
4
5
(A)
1
3
5
4
3
4
6
2
1
3
2
1
2
• For passenger air bag (inflator) module
i) Clear space (1) on ground about 185 cm (6 ft) in diameter
where passenger air bag (inflator) module for deployment.
Paved, outdoor location where there is no activity is pre-
ferred. If outdoor location is not available, space on shop
floor where there is no activity and provide sufficient venti-
lation. Ensure no loose or flammable objects are within
deployment area.
ii) Place deployment fixture (A) on ground in step i).
Special tool
(A): 09932-75041
iii) Fill plastic reservoir in deployment fixture (A) with water or
sand. This is necessary to provide sufficient stabilization
of fixture during deployment.
iv) Attach passenger air bag (inflator) module (2) in deploy-
ment fixture (A) using mounting attachment (3), hold-down
bolts & nuts (4) and M8 bolts & nuts (5).
NOTE:
Make sure that deploying direction (6) faces as shown in
figure against mounting attachment (3).
CAUTION:
Be sure to use M8 size and 7T strength bolts and nut (5)
for fixing passenger air bag (inflator) module (2) to
mounting attachment (3).
• For side air bag (inflator) module
i) Clear space (3) on ground about 185 cm (6 ft) in diameter
where side air bag (inflator) module (1) for deployment.
Paved, outdoor location where there is no activity is pre-
ferred. If outdoor location is not available, space on shop
floor where there is no activity and provide sufficient venti-
lation. Ensure no loose or flammable objects are within
deployment area.
ii) Place front seat back (2) with side air bag (inflator) module
(1) with its frontal seat cover facing up on ground in step i).
• For seat belt pretensioner
i) Cut webbing (1) at tongue plate stopper (2) of seat belt
pretensioner (3) side as shown.
NOTE:
Hold seat belt pretensioner (3) vertically in the same con-
dition as it is installed. Otherwise, webbing can't be
pulled out.
ii) Remove tongue plate (4) and shoulder anchor (5) from
webbing.