Suzuki Ignis Service Manual page 3933

10B-32 AIR BAG SYSTEM
Step
3 1) With ignition switch OFF, disconnect Spe-
cial Tool (B) and (C), then reconnect con-
tact coil connector "L71" located near the
base of the steering column.
2) Remove driver air bag (inflator) module
from steering wheel (Refer to "Driver Air
Bag (Inflator) Module Removal and Installa-
tion" in Section 3C).
3) Check proper connection to driver air bag
(inflator) module at terminals in driver air
bag (inflator) module connector.
4) If OK, then connect Special Tool (B) and (C)
to driver air bag (inflator) module connector.
With ignition switch ON, is DTC B1025 current?
[A]
BASE OF COLUMN
[A]: Fig. for STEP 1 and 2
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78340
(D): 09932-78310
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
[B]
(C)
(B)
[B]: Fig. for STEP 2 [C]: Fig. for STEP 3
Yes
Ignition switch OFF.
Replace contact coil
assembly (Refer to "Con-
tact Coil Cable Assembly
Removal and Installation"
in Section 3C).
(A)
"L21-26" "L21-27"
(A)
No
Ignition switch OFF.
Replace driver air bag
(inflator) module (Refer to
"Driver Air Bag (Inflator)
Module Removal and
Installation" in Section
3C).
[C]