Table of Contents
Advertisement
9-16 BODY SERVICE
2
"a"
1
2
1
"a"
10) Using knife (1), smoothen adhesive (2) remaining on body
side (3) so that it is 1 – 2 mm (0.039 – 0.078 in.) thick all
around.
NOTE:
Before using knife (1), clean it with alcohol or the like to
remove oil from it.
11) When reusing windshield, remove the adhesive (1) from it,
using care not to damage primer coated surface (2).
INSTALLATION
1) Using cleaning solvent, clean windshield edge where wind-
shield glass is to be adhered. (Let it dry for 10 minutes or
more.)
2) Install new glass stoppers (1) (2 pieces) to lower side of
windshield.
3) To determine installing position of glass (1) to body (2), posi-
tion glass against body so that clearance between upper end
of glass (1) and body (2) is approximately 5 mm (0.197 in.)
and clearances between each side end (right & left) of glass
(1) and body (2) are even. Then mark mating marks on glass
(1) and body (2) as shown. Upper clearance can be adjusted
by moving glass stoppers position.
Windshield clearance
"a": approx. 5 mm (0.197 in.)
Advertisement
Table of Contents
