Table of Contents
Advertisement
2
1
3
14) Separate two banana plugs (1) on deployment harness (2).
15) Connect deployment harness (2) to 12 volts vehicle battery
(3). This will immediately deploy or activate air bag (inflator)
module or seat belt pretensioner.
16) Disconnect deployment harness (2) from 12 volts vehicle
battery (3) and short two deployment harness leads together
by fully seating one banana plug into the other.
17) Repeat Steps 2) through 16) to deploy/activate air bag (infla-
tor) modules and seat belt pretensioners which has not been
deployed/activated, if any.
18) In the unlikely event that air bag (inflator) module and seat
belt pretensioner after following these procedures, proceed
immediately with Step 24) through 26). If air bag (inflator)
module and seat belt pretensioner did deploy/activate, pro-
ceed with Steps 19) through 23).
19) Carefully remove drop cloth from vehicle and clean off any
fragments or discard it entirely.
20) Put on pair of shop gloves to protect your hands from possi-
ble irritation and heat when handling deployed air bag (infla-
tor) module and activated seat belt pretensioner.
21) Disconnect adapter cable (special tool) from air bag (inflator)
module or seat belt pretensioner as soon as possible. This
will prevent adapter cable (special tool) from damage due to
possible contact with hot air bag (inflator) module or hot seat
belt pretensioner.
22) Check adapter cable connector as follows.
• For air bag (inflator) module:
Air bag (inflator) module connector of adapter cable (special
tool) are designed to be reused. However they should be
inspected for damage after deployment and replaced if nec-
essary.
• For seat belt pretensioner:
Seat belt pretensioner connector of adapter cable (special
tool) must be replaced to spare connector (special tool).
NOTE:
Do not reuse seat belt pretensioner connector of adapter
cable (special tool) because it will be destroyed by shock
when seat belt pretensioner is activated.
23) With air bag (inflator) modules deployed and seat belt pre-
tensioners activated, vehicle may be scrapped in the same
manner as non-air bag system/seat belt pretensioner
equipped vehicle.
AIR BAG SYSTEM 10B-91
Advertisement
Table of Contents
