Table of Contents
Advertisement
Rear Door Removal and Installation
1. Rear door panel
2. Rear door hinge
: Apply lithium grease 99000-25010 to rotating part
: Apply sealant 99000-31110 to contact face
3. Rear door stopper pin
2
Refer to "Front Door Removal and Installation" in this section not-
ing the following instructions.
• Refer to above figure for tightening torque, grease and seal-
ant.
• Install door open stopper (1) as specified below.
Door open stopper installing direction
Right side door: RR punch mark is upward.
Left side door: RL punch mark is upward.
2. Punch mark
1
4. Door open stopper
5. Rear door hinge bolt
Tightening torque
BODY SERVICE 9-25
Do not reuse.
Advertisement
Table of Contents
