Table of Contents
Advertisement
4) Drive out bevel gear (1) using special tool.
Special tool
(A): 09913-65135
Assembly
CAUTION:
• Bevel gear and pinion must be replaced as a set when
either replacement becomes necessary.
• When replacing taper roller bearing, replace as inner
race & outer race assembly.
1) Drive in bevel gear to reduction driven gear.
2) Tighten bevel gear nut to specified torque while holding
bevel gear with special tool and vise (1), and then caulk nut.
Tightening torque
Transfer bevel gear nut
: 150 N·m (15.0 kg-m, 108.5 lb.-ft.)
Special tool
(B): 09941-58020
(C): 09924-57610
3) Press-fit driven gear bearings (2) (right and left) to driven
gear using special tools.
Special tool
(A): 09945-16070
NOTE:
Support shaft with special tool as illustrated in the figure
so that retainer of bearing cone will be free from com-
pression.
1. Plate
TRANSFER 7D-13
Advertisement
Table of Contents
