Table of Contents
Advertisement
• Sealant gun (for filling adhesive)
• Putty spatula (for correcting adhered parts)
REMOVAL
1) Clean both inside and outside of glass and around it.
2) Remove wiper arms and garnish.
3) Using tape, cover body surface around glass to prevent any
damage.
4) Remove rear view mirror, sun visor, and front pillar trims
(right & left).
5) If necessary, remove instrument panel. Refer to "Instrument
Panel Removal and Installation" in this section.
6) If necessary, remove head lining. Refer to "Head Lining
Removal and Installation" in this section.
7) Remove (or cut) windshield molding.
8) Drill hole with eyeleteer (1) through adhesive and let piano
string through it.
9) Cut adhesive all around windshield (1) with piano string (2).
When using tool, windshield knife (3), to cut adhesive, be
careful not to cause damage to windshield. Use wire to cut
adhesive along lower part of windshield.
NOTE:
Use piano string (2) as close to glass as possible so as to
prevent damage to body and instrument panel.
BODY SERVICE 9-15
Advertisement
Table of Contents
