Suzuki Ignis Service Manual page 3685

7D-18 TRANSFER
"a"
"A"
Assembly
1) Press-fit pinion shaft bearing outer races (front and rear)
using special tools.
Special tool
(A) : 09913-75821
(B) : 09924-84510-005
2) Press-fit pinion shaft bearing (front side) (1) using special
tool, press and pinion shaft spacer (2).
Special tool
(A) : 09913-75810
NOTE:
Use pinion shaft spacer "Which was assembled to trans-
fer" in this procedure, and install new pinion shaft spacer
at next step.
3) Install bevel pinion shaft with new pinion shaft spacer (1) to
transfer output retainer.
4) Press-fit pinion shaft bearing (rear side) (2) using special tool
(and press).
Special tool
(A) : 09913-75810
CAUTION:
Press-fit bearing to such an extent that spacer is not
compressed.
5) Drive in oil seal (1) using special tools and apply grease to
oil seal lip.
(A)
Special tool
(A) : 09913-70123
(B)
(B) : 09924-07720
1
"A" : Grease 99000-25010
Transfer bevel pinion shaft oil seal installing depth
2
"a" : 27.0 – 27.5 mm (1.063 – 1.083 in.)
2. Bevel pinion shaft