Table of Contents
Advertisement
6A1-80 ENGINE MECHANICAL (M13 ENGINE)
[A] : Sealant application amount
[B] : 1) Tighten all bolts to 30 N·m (3.0 kg-m)
2) Tighten all bolts to 50 N·m (5.0 kg-m)
3) Then retighten all bolts by turning
through 60°
Tightening torque
Do not reuse.
Apply engine oil to inside / sliding surface.
"a" : 3 mm (0.12 in.)
"b" : 2 mm (0.08 in.)
1. CKP sensor (if equipped)
: When installing CKP sensor, use new
sensor mounting bolt.
2. Knock sensor
3. Cylinder block
4. Venturi plug
5. Main bearing
: Upper half of bearing has an oil
groove
6. Sensor plate
7. Crankshaft timing sprocket key
8. Crankshaft
9. Thrust bearing
10. Rear oil seal housing
: Apply sealant 99000-31250 to mat-
ing surface.
11. Rear oil seal
12. Input shaft bearing
13. Flywheel
Main Bearings, Crankshaft and Cylinder
Block Removal and Installation
Removal
1) Remove engine assembly from vehicle referring to "Engine
Assembly Removal and Installation" in this section.
2) Remove clutch cover, clutch disc and flywheel (drive plate
for A/T) by using special tool.
Special tool
(A) : 09924-17810
3) Remove piston and connecting rod referring to "Pistons, Pis-
ton Rings, Connecting Rods and Cylinders Removal and
Installation" in this section.
4) Remove rear oil seal housing (1).
14. Main bearing cap
15. Flywheel mounting bolt
16. Rear oil seal housing mounting bolt
17. Main bearing cap No.2 bolt
18. Main bearing cap No.1 bolt
: Never reuse main bearing cap
No.1 bolts once disassembled it due
to plastic deformation tightening.
Be sure to use new main bearing
cap No.1 bolts when installing.
19. O-ring
20. Oil filter adapter case
21. Oil filter adapter bolt
22. Spring pin
23. Sensor plate bolt
Advertisement
Table of Contents
