Configuring The Maintenance Association Intermediate Points With Bridge Domain When Maintenance Association End Point Is Configured - Juniper ACX1000 Configuration Manual

Configuring the Maintenance Association Intermediate Points with Bridge Domain
Configuring the Maintenance Association Intermediate Points with Circuit Cross-Connect
Configuring the Maintenance Association Intermediate Points with Bridge Domain when
Maintenance Association End Point is Configured
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
In ACX5048 and ACX5096 routers, you can configure the MIP with bridge domain. The
following is a sample to configure the MIP with bridge domain:
[edit protocols]
oam {
ethernet {
connectivity-fault-management {
maintenance-domain default-6 {
vlan bd1;
mip-half-function default;
}
}
}
}
In ACX5048 and ACX5096 routers, you can configure the MIP with circuit cross-connect
(CCC). The following is a sample to configure the MIP with CCC:
[edit protocols]
oam {
ethernet {
connectivity-fault-management {
maintenance-domain default-6 {
interface xe-0/0/42.0;
mip-half-function default;
}
}
}
}
In ACX5048 and ACX5096 routers, you can configure the MIP with bridge domain when
a maintenance association end point (MEP) is configured. The following is a sample to
configure the MIP with bridge domain when MEP is configured:
[edit protocols]
oam {
ethernet {
connectivity-fault-management {
maintenance-domain md2 {
level 5;
mip-half-function default;
maintenance-association ma2 {
continuity-check {
interval 1s;
}
mep 222 {
interface xe-0/0/42.0;
direction up;
1131