Juniper ACX1000 Configuration Manual page 1438

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
1380
user@host# set test-profile throughput
Specify the logical interface, ge-0/0/0.1, on which the RFC 2544-based
20.
benchmarking test is run.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface ge-0/0/0.1
Specify the test mode for the packets that are sent during the benchmarking test
21.
as initiation and termination.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set mode initiate-and-terminate
Configure the address type family,
22.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family inet
Configure the destination IPv4 address for the test packets as 200.0.0.2.
23.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set dest-address 200.0.0.2
Specify the UDP port of the destination to be used in the UDP header for the
24.
generated frames as 4001.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set udp-port 4001
Configuring Benchmarking Test Parameters on Router B
The following example requires you to navigate various levels in the configuration
hierarchy. For information about navigating the CLI, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure the test parameters on Router B:
In configuration mode, go to the
1.
[edit]
user@host# edit interfaces
Configure the interface on which the test must be run.
2.
[edit interfaces]
user@host# edit ge-0/0/4
Configure VLAN tagging for transmission and reception of 802.1Q VLAN-tagged
3.
frames.
[edit interfaces ge-0/0/4]
, for the benchmarking test.
inet
hierarchy level:
[edit interfaces]
Copyright © 2017, Juniper Networks, Inc.