Juniper ACX1000 Configuration Manual page 1241

Table 91: jnxSoamLmCfgTable (continued)
Object
jnxSoamLmCfgAlignMeasurementIntervals
jnxSoamLmCfgAlignMeasurementOffset
jnxSoamLmCfgSessionType
jnxSoamLmCfgSessionStatus
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Object ID Description
Specifies whether the Measurement Intervals for the Loss
JnxSoamLmCfgEntry
Measurement session are aligned with a zero offset to real
19
time.
The value 'true' indicates that each Measurement Interval
starts at a time which is aligned to NE time source hour,
if the repetition time (or the Measurement Interval, if the
repetition time is 0) is a factor of an hour, that is,
60min/15min = 4. For instance, a Measurement
Interval/repetition time of 15 minutes would stop/start
the Measurement Interval at 0, 15, 30, and 45 minutes of
an hour. A Measurement Interval/Repetition Time of 7
minutes would not align to the hour since 7 minutes is NOT
a factor of an hour, that is, 60min/7min = 8.6. In this case
the behavior is the same as if the object is set to 'false'.
The value 'false' indicates that the first Measurement
Interval starts at an arbitrary time and each subsequent
Measurement Interval starts at a time which is determined
by jnxSoamLmCfgRepetitionTime.
This object can only be written at row creation time and
cannot be modified once it has been created.
Specifies the offset in minutes from the time of day value
JnxSoamLmCfgEntry
if jnxSoamLmCfgAlignMeasurementIntervals is 'true' and
20
the repetition time is a factor of 60 minutes. If not, the
value of this object is ignored.
If the Measurement Interval is 15 minutes and
jnxSoamLmCfgAlignMeasurementIntervals is true and if
this object was set to 5 minutes, the Measurement
Intervals would start at 5, 20, 35, 50 minutes past each
hour.
This object can only be written at row creation time and
cannot be modified once it has been created. "
JnxSoamLmCfgEntry Indicates whether the current session is defined to be
'Proactive' or 'On-Demand'. A value of 'proactive' indicates
21
the current session is 'Proactive'. A value of 'onDemand'
indicates the current session is 'On-Demand'. This object
can only be written at row creation time and cannot be
modified once it has been created.
JnxSoamLmCfgEntry indicates the current status of the LM session. A value of
'active' indicates the current LM session is active, i.e. the
22
current time lies between the start time and the stop time,
and jnxSoamLmCfgEnabled is true. A value of 'notActive'
indicates the current LM session is not active, i.e. it has not
started yet, has stopped upon reaching the stop time, or
is disabled.
1183