Configuring Vlan Ids For Logical Interfaces; Sample Scenario Of Hierarchical Virtual Private Lan Service On Logical Tunnel Interface - Juniper ACX1000 Configuration Manual

Configuring VLAN IDs for Logical Interfaces

Sample Scenario of Hierarchical Virtual Private LAN Service on Logical Tunnel Interface

Copyright © 2017, Juniper Networks, Inc.
[edit interfaces interface-name]
Gigabit Ethernet interfaces can be partitioned. You can assign up to 4095 different logical
interfaces, one for each VLAN, but you are limited to a maximum of 1024 VLANs on any
single Gigabit Ethernet or 10-Gigabit Ethernet port.
You can bind a VLAN identifier to a logical interface by including the
vlan-id number;
You can include this statement at the following hierarchy levels:
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
You can also configure a logical interface to forward packets and learn MAC addresses
within each VPLS routing instance configured with a VLAN ID that matches a VLAN ID
specified in a list using the
using a space to separate each ID, entered as an inclusive list separating the starting
VLAN ID and ending VLAN ID with a hyphen, or a combination of both.
For example, to configure the VLAN IDs 20 and 45 and the range of VLAN IDs between
30 and 40, issue the following command from the CLI:
set interfaces ge-1/0/1 unit 1 vlan-id-list [20 30-40 45];
To configure a list of VLAN IDs for a logical interface, include the
vlan-id-list list-of-vlan-ids;
You can include this statement at the following hierarchy levels:
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
NOTE: ACX Series routers do not support the
For more information about how to configure VLANs, see the Junos OS Network Interfaces
Library for Routing Devices. For detailed information about how VLAN identifiers in a VPLS
routing instance are processed and translated, see the MX Series Layer 2 Configuration
Guide.
This section describes how to configure the hierarchical virtual private LAN service
(H-VPLS) on ACX5048 and ACX5096 routers. Junos OS for ACX5048 and ACX5096
routers supports configuring H-VPLS using the logical tunnel interface encapsulation.
Chapter 35: Configuring Virtual Private LAN Service
vlan-id-list statement. VLAN IDs can be entered individually
statement:
vlan-id
statement:
vlan-id-list
hierarchy.
[edit logical-systems]
1259