Services - Juniper ACX1000 Configuration Manual

Related
Documentation
Example: Configuring an RFC 2544-Based Benchmarking Test for Layer 3 IPv4 Services
Requirements
Overview
Copyright © 2017, Juniper Networks, Inc.
RFC 2544-Based Benchmarking Tests Overview on page 1335
Layer 2 and Layer 3 RFC 2544-Based Benchmarking Test Overview on page 1338
Configuring RFC 2544-Based Benchmarking Tests on page 1341
show services rpm rfc2544-benchmarking on page 3156
show services rpm rfc2544-benchmarking test-id on page 3161
This example shows how to configure the benchmarking test for a Layer 3 IPv4 service.
NOTE: This example is not applicable for ACX5048 and ACX5096 routers.
Requirements on page 1359
Overview on page 1359
Configuration on page 1360
Verifying the Results of the Benchmarking Test for Layer 3 IPv4 Services on page 1366
This example uses the following hardware and software components:
An ACX Series router
Junos OS Release 12.3X53 or later
Consider a sample topology in which a router, Router A, functions as an initiator and
terminator of the test frames for an RFC 2544-based benchmarking test. Router A is
connected over a Layer 3 network to another router, Router B, which functions as a
reflector to reflect back the test frames it receives from Router A. IPv4 is used for
transmission of test frames over the Layer 3 network. This benchmarking test is used to
compute the IPv4 service parameters between Router A and Router B. Logical interfaces
on both the routers are configured with IPv4 addresses to measure the performance
attributes, such as throughput, latency, frame loss, and bursty frames, of network devices
for the IPv4 service.
Figure 71 on page 1360 shows the sample topology to perform an RFC 2544 test for a Layer
3 IPv4 service.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
1359