Juniper ACX1000 Configuration Manual page 1423

Copyright © 2017, Juniper Networks, Inc.
user@host# set mode reflect
Configure the address type family,
13.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family inet
Configure the destination IPv4 address for the test packets as 200.0.0.1.
14.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set dest-address 200.0.0.1
Specify the UDP port of the destination to be used in the UDP header for the
15.
generated frames as 4001.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set udp-port 4001
Start the benchmarking test on the reflector.
16.
user@host> test services rpm rfc2544-benchmarking test test1 start
After the test is successfully completed at the initiator, you can stop the test at the
reflector by entering the
command.
Results
In configuration mode, confirm your configuration on Router A and Router B by entering
the command. If the output does not display the intended configuration, repeat
show
the configuration instructions in this example to correct it.
Configuring Benchmarking Test Parameters on Router A:
[edit interfaces]
ge-0/0/0 {
unit 0 {
family inet {
address 200.0.0.1/24;
}
}
}
[edit services rpm]
rfc2544-benchmarking {
profiles {
test-profile throughput {
test-type throughput
packet-size 64;
test-duration 20m;
bandwidth-kbps 500;
}
}
tests {
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
, for the benchmarking test.
inet
test services rpm rfc2544-benchmarking test test1 start
1365