Configuring Services Interface; Configuring Next-Hop Service Sets - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Configuring Services Interface

Configuring Next-Hop Service Sets

1032
An interface service set is used as an action modifier across an entire interface. To
configure the services interface, include the
[edit services service-set service-set-name]
[edit services service-set service-set-name]
interface-service {
service-interface interface-name;
}
Only the interface name is needed, because Junos OS manages logical unit numbers
automatically. The services interface must be an inline-services interface for which you
have configured
unit 0 family inet
When you have defined and grouped the service rules by configuring the service-set
definition, you can apply services to one or more interfaces installed on the router. When
you apply the service set to an interface, it automatically ensures that packets are directed
to the Network Address Translation (NAT) engine.
To associate a defined service set with an interface, include the
with the input and output
logical-unit-number family inet service]
[edit interfaces interface-name unit logical-unit-number family inet service]
input {
service-set service-set-name <service-filter filter-name>;
}
output {
service-set service-set-name <service-filter filter-name>;
}
You configure the same service set on the input and output sides of the interface. You
can optionally include filters associated with each service set to refine the target and
additionally process the traffic. If you include the
definition, Junos OS assumes that the match condition is true and selects
service-filter
the service set for processing automatically.
NOTE: If you configure service sets with filters, you must configure the service
sets on the input and output sides of the interface.
A next-hop service set is a route-based method of applying a particular service. Only
packets destined for a specific next hop are serviced by the creation of explicit static
routes. This configuration is useful when services need to be applied to an entire virtual
routing and forwarding (VRF) table, or when routing decisions determine that services
need to be performed.
interface-service
hierarchy level:
at the [
edit interfaces interface-name
statement at the [edit interfaces interface-name unit
hierarchy level:
service-set
statement at the
] hierarchy level.
statement
service-set
statement without a
Copyright © 2017, Juniper Networks, Inc.