Juniper ACX1000 Configuration Manual page 1367

Step-by-Step
Procedure
user@PE5# show vpls connections extensive
...
Instance: H-VPLS
Number of local interfaces: 1
Number of local interfaces up: 1
Number of VE mesh-groups: 2
Number of VE mesh-groups up: 1
ge-2/0/0.0
Mesh-group interfaces: L2-Circuits
State: Up ID: 2
vt-2/1/0.1048848
vt-2/1/0.1048849
vt-2/1/0.1048850
Mesh-group interfaces: __ves__
State: Dn ID: 0
Mesh-group connections: L2-Circuits
Neighbor
192.0.2.4(vpls-id 100)
Remote PE: 192.0.2.4, Negotiated control-word: No
Incoming label: 800011, Outgoing label: 301088
Local interface: vt-2/1/0.1048848, Status: Up, Encapsulation: ETHERNET
Copyright © 2017, Juniper Networks, Inc.
On Router PE3, configure the mesh group by including the
4.
at the
[edit routing-instances H-VPLS protocols vpls]
L2-Circuits as the name of the group. Include the
as the ID value. Include the
traffic between the pseudowires.
For each neighbor in the mesh group, include the
the IPv4 address of the spoke PE router.
[edit routing-instances H-VPLS protocols vpls]
mesh-group L2-Circuits {
vpls-id 100; <<< Same VPLS ID on all MTUs
local-switching; << Local-switching enabled
neighbor 192.0.2.1; <<MTU IP addresses
neighbor 192.0.2.2;
neighbor 192.0.2.4;
}
Verification
On Router PE5, use the
1.
have been created to each of the spoke PE routers.
user@PE5# show ldp neighbor
Address
192.0.2.1
192.0.2.2
192.0.2.4
On Router PE5, use the
2.
the mesh group neighbor session is
been assigned, that the VPLS ID is correct, and that the virtual tunnel interface is
being used.
Intf - vpls H-VPLS neighbor 192.0.2.4 vpls-id 100
Intf - vpls H-VPLS neighbor 192.0.2.2 vpls-id 100
Intf - vpls H-VPLS neighbor 192.0.2.1 vpls-id 100
Type St Time last up
rmt Up Jan
Chapter 35: Configuring Virtual Private LAN Service
statement to enable the router to switch
local-switching
show ldp neighbor command to verify that LDP sessions
Interface Label space ID
lo0.0 192.0.2.1:0
lo0.0 192.0.2.2:0
lo0.0 192.0.2.4:0
show vpls connections extensive
Up , that inbound and outbound labels have
# Up trans
3 16:46:26 2010
statement
mesh-group
hierarchy level and specifying
vpls-id statement and specify
neighbor statement and specify
Hold time
33
37
39
command to verify that
1
100
1309