Juniper ACX1000 Configuration Manual page 1422

ACX Series Universal Access Router Configuration Guide
1364
user@host# edit ge-0/0/4
Configure a logical unit and specify the protocol family as
3.
[edit interfaces ge-0/0/4]
user@host# edit unit 0 family inet
Specify the address for the logical interface.
4.
[edit interfaces ge-0/0/4 unit 0 family inet]
user@host# set address 200.0.0.2/24
Enter the command to go the previous level in the configuration hierarchy.
up
5.
[edit interfaces ge-0/0/4 unit 0 family inet]
user@host# up
Go to the top level of the configuration command mode.
6.
[edit interfaces ge-0/0/4 unit 0]
user@host# top
In configuration mode, go to the
7.
[edit]
user@host# edit services
Configure a real-time performance monitoring service (RPM) instance.
8.
[edit services]
user@host# edit rpm
Configure an RFC 2544-based benchmarking test for the RPM instance.
9.
[edit services rpm]
user@host# edit rfc2544-benchmarking
Define a name for the test—for example, test1. The test name identifier can be up
10.
to 32 characters in length.
[edit services rpm rfc2544-benchmarking]
user@host# edit tests test-name test1
Specify the logical interface, ge-0/0/4.1, on which the RFC 2544-based
11.
benchmarking test is run.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface ge-0/0/4.1
Specify as the test mode for the packets that are sent during the
reflect
12.
benchmarking test.
[edit services rpm rfc2544-benchmarking tests test-name test1]
inet
[edit services] hierarchy level.
Copyright © 2017, Juniper Networks, Inc.
.