Example: Configuring An Rfc 2544-Based Benchmarking Test For Uni Direction Of Ethernet Pseudowires - Juniper ACX1000 Configuration Manual

Purpose
Action
Meaning
Related
Documentation
Example: Configuring an RFC 2544-Based Benchmarking Test for UNI Direction of
Ethernet Pseudowires
Requirements
Copyright © 2017, Juniper Networks, Inc.
Verifying the Benchmarking Test Results
Verify that the necessary and desired statistical values are displayed for the benchmarking
test that is run on the configured service between Router A and Router B.
In operational mode, enter the
| active-tests | completed-tests | summary)
results of each category or state of the RFC 2544-based benchmarking test, such as
aborted tests, active tests, and completed tests, for each real-time performance
monitoring (RPM) instance.
The output displays the details of the benchmarking test that was performed. For more
information about the
run show services rpm rfc2544-benchmarking
see show services rpm rfc2544-benchmarking
Configuring RFC 2544-Based Benchmarking Tests on page 1341
rfc2544-benchmarking on page 1698
profiles on page 1678
tests on page 1749
show services rpm rfc2544-benchmarking on page 3156
show services rpm rfc2544-benchmarking test-id on page 3161
This example shows how to configure the benchmarking test for the user-to-network
interface (UNI) direction of an Ethernet pseudowire service.
Requirements on page 1375
Overview on page 1376
Configuration on page 1377
Verifying the Results of the Benchmarking Test for UNI Direction of an Ethernet
Pseudowire Service on page 1383
This example uses the following hardware and software components:
An ACX Series router
Junos OS Release 12.3X53 or later
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
run show services rpm rfc2544-benchmarking (aborted-tests
command to display information about the
in the CLI Explorer
operational command,
.
1375