Service Scaling On Acx5048 And Acx5096 Routers; Understanding Layer 2 Next Generation Mode On Acx5048 And Acx5096; Routers - Juniper ACX1000 Configuration Manual

Service Scaling on ACX5048 and ACX5096 Routers

Related
Documentation
Understanding Layer 2 Next Generation Mode on ACX5048 and ACX5096 Routers
Table 84: Differences in CLI Hierarchy for Layer 2 Features in Layer 2 Next Generation Mode
Feature
Bridge Domain
Family bridge
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
NOTE: As shown in the example, you will need to run the
and
show pfe tcam usage
configurations are valid and that the applications using TCAM resource are
in OK state.
In ACX5048 and ACX5096 routers, a typical service (such as ELINE, ELAN and IP VPN)
that is deployed might require applications (such as policers, firewall filters, connectivity
fault management IEEE 802.1ag, RFC2544) that uses the dynamic TCAM infrastructure.
NOTE: Service applications that uses TCAM resources is limited by the TCAM
resource availability. Therefore, the scale of the service depends upon the
consumption of the TCAM resource by such applications.
A sample use case for monitoring and troubleshooting service scale in ACX5048 and
ACX5096 routers can be found at the
Overview" on page 1157 section.
The Layer 2 Next Generation mode, also called Enhanced Layer 2 Software (ELS), is
supported on ACX5048 and ACX5096 routers for configuring Layer 2 features. The Layer
2 CLI configurations and show commands for ACX5048 and ACX5096 routers differ
from those for other ACX Series routers (ACX1000, ACX1100, ACX2000, ACX2100,
ACX2200, and ACX4000) and MX Series routers.
For more information about Enhanced Layer 2 Software, see
.
Layer 2 Software
Table 84 on page 1167 shows the differences in CLI hierarchy for configuring Layer 2 features
in Layer 2 next generation mode.
ACX1000, ACX1100, ACX2000, ACX2100,
ACX2200, ACX4000, and MX Series Routers
[ edit bridge-domains bridge-domain-name
[ edit interfaces interface-name unit unit-number
family bridge ]
commands at each step to ensure that your
"Dynamic Ternary Content Addressable Memory
Getting Started with Enhanced
ACX5048 and ACX5096 Routers
] [ edit vlans vlan-name
[ edit interfaces interface-name unit
unit-number family ethernet-switching
show pfe tcam errors
]
]
1167