Juniper ACX1000 Configuration Manual page 706

ACX Series Universal Access Router Configuration Guide
Meaning
Purpose
Action
648
Jan 24 11:06:36 2013
Jan 24 11:06:36 2013
user@PE2> show l2circuit connections extensive
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid
MM -- mtu mismatch
EM -- encapsulation mismatch
CM -- control-word mismatch
VM -- vlan id mismatch
OL -- no outgoing label
NC -- intf encaps not CCC/TCC
BK -- Backup Connection
CB -- rcvd cell-bundle size bad
LD -- local site signaled down
RD -- remote site signaled down
XX -- unknown
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 192.168.0.100
Interface
lt-1/2/0.600(vc 2)
Remote PE: 192.168.0.100, Negotiated control-word: Yes (Null)
Incoming label: 299776, Outgoing label: 299792
Negotiated PW status TLV: Yes
local PW status code: 0x00000000, Neighbor PW status code: 0x00000020
Local interface: lt-1/2/0.600, Status: Up, Encapsulation: VLAN
Connection History:
Jan 24 10:55:31 2013
Jan 24 10:55:31 2013
Jan 24 10:55:31 2013
Jan 24 10:55:31 2013
Jan 24 10:55:31 2013
From the perspective of Device PE1 and Device PE2, a single Layer 2 circuit is established
toward access routers, so there is no standby device information in the CLI output of the
show l2circuit connections
provided for the VC acting as the hot-standby. Junos OS allows only these counters to
be tracked for the active VC.
Checking the Policy Conditions
On the PE devices, verify the state of the different conditions defined as part of the Layer3
VPN's egress policy, where 10.41.0.0/24 corresponds to the logical tunnel (y) subnet.
From operational mode, enter the
user@PE1> show policy conditions detail
In lbl Update
loc intf up
NP -- interface h/w not present
Dn -- down
VC-Dn -- Virtual circuit Down
Up -- operational
CF -- Call admission control failure
IB -- TDM incompatible bitrate
TM -- TDM misconfiguration
ST -- Standby Connection
SP -- Static Pseudowire
RS -- remote site standby
HS -- Hot-standby Connection
Type St Time last up
rmt Up Jan 24 10:55:31 2013
status update timer
PE route changed
Out lbl Update
In lbl Update
loc intf up
command. Note that no timing and flapping information is
show policy conditions detail
299776
lt-1/2/0.600
# Up trans
299792
299776
lt-1/2/0.600
command.
Copyright © 2017, Juniper Networks, Inc.
1