Configuring The Vpls Interface Name; Configuring Vpls Interface Encapsulation - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Configuring the VPLS Interface Name

Configuring VPLS Interface Encapsulation

1256
Specify both the physical and logical portions of the interface name, in the following
format:
physical.logical
For example, in ge-1/2/1.2 ,
the logical portion. If you do not specify the logical portion of the interface name,
by default.
A logical interface can be associated with only one routing instance.
If you enable a routing protocol on all instances by specifying
configuring the master instance of the protocol at the
and you configure a specific interface for VPLS routing at the
hierarchy level, the latter interface statement takes precedence
routing-instance-name]
and the interface is used exclusively for VPLS.
If you explicitly configure the same interface name at both the
routing-instances routing-instance-name]
the configuration, the commit operation fails.
You need to specify an encapsulation type for each PE-router-to-CE-router interface
configured for VPLS. This section describes the
options available for VPLS.
To configure the encapsulation type on the physical interface, include the
statement:
encapsulation (ethernet-vpls | ether-vpls-over-atm-llc |extended-vlan-vpls | vlan-vpls);
NOTE: ACX Series routers do not support the
extended-vlan-vpls
You can include the
encapsulation
hierarchy levels:
[edit interfaces interface-name]
[edit logical-systems logical-system-name interfaces interface-name]
NOTE: ACX Series routers do not support the
ge-1/2/1 is the physical portion of the interface name and
hierarchy levels and then attempt to commit
encapsulation
options for encapsulation.
statement for physical interfaces at the following
when
interfaces all
hierarchy level,
[edit protocols]
[edit routing-instances
[edit protocols] and
statement configuration
encapsulation
ether-vpls-over-atm-llc
hierarchy.
[edit logical-systems]
Copyright © 2017, Juniper Networks, Inc.
2 is
is set
0
[edit
and