Configuring Vlan Identifiers For Bridge Domains In Acx Series - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Configuring VLAN Identifiers for Bridge Domains in ACX Series

Related
Documentation
764
irb {
unit 0 {
family inet {
address 10.0.1.2/24 {
}
}
}
}
bridge-domains {
bd {
domain-type bridge;
vlan-id none;
interface ge-1/0/0.0;
interface ge-1/0/1.0;
routing-interface irb.0;
}
}
You can configure VLAN identifiers for a bridge domain for normalization in the following
ways:
Configure VLAN mapping by using the
statements at the [edit interfaces interface-name]
Configure an implicit normalizing VLAN identifier under the bridge domain by using the
statement at the
vlan-id
NOTE: You cannot configure VLAN mapping by using the
output-vlan-map
for a bridge domain by using the
You can use the vlan-id-list [ vlan-id-numbers ]
VLANs. Configuring this statement creates a bridge domain for:
Each VLAN listed—for example,
Each VLAN in a range—for example,
Each VLAN in a list and range combination—for example,
300 ]
Layer 2 Bridge Domains on ACX Series Overview on page 755
Q-in-Q Tunneling on ACX Series Overview on page 770
Layer 2 Learning and Forwarding for Bridge Domains Overview on page 759
input-vlan-map
hierarchy level.
[edit bridge-domains bridge-domain-name]
statements if you configure a normalizing VLAN identifier
vlan-id statement.
statement to configure bridging for multiple
vlan-id-list [ 100 200 300 ]
vlan-id-list [ 100-200 ]
and the
output-vlan-map
hierarchy level.
input-vlan-map
vlan-id-list [ 50, 100-200,
Copyright © 2017, Juniper Networks, Inc.
and