Juniper ACX1000 Configuration Manual page 694

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
636
Apply the per-packet load balancing policy.
8.
[edit routing-options forwarding-table]
user@A1# set export pplb
Configure the autonomous system (AS) ID and the router ID.
9.
[edit routing-options]
user@A1# set router-id 192.168.0.100
user@A1# set autonomous-system 64510
Similarly, configure any other access devices.
The following example requires you to navigate various levels in the configuration
hierarchy. For information about navigating the CLI, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure Device PE1:
Configure the interfaces.
1.
Enable MPLS on the core-facing interfaces.
[edit interfaces]
user@PE1# set ge-0/1/1 unit 0 family inet address 10.21.0.101/24
user@PE1# set ge-0/1/1 unit 0 family iso
user@PE1# set ge-0/1/1 unit 0 family mpls
user@PE1# set ge-0/1/2 unit 0 family inet address 10.31.0.101/24
user@PE1# set ge-0/1/2 unit 0 family iso
user@PE1# set ge-0/1/2 unit 0 family mpls
user@PE1# set ge-0/1/3 unit 0 family inet address 10.10.0.101/24
user@PE1# set ge-0/1/3 unit 0 family iso
user@PE1# set ge-0/1/3 unit 0 family mpls
user@PE1# set lo0 unit 0 family inet address 192.168.0.101/32 primary
user@PE1# set lo0 unit 0 family iso address 49.0002.0192.0168.0003.00
user@PE1# set lo0 unit 1 family inet address 192.168.1.101/32
On Device PE1 and Device PE2, which are aggregation routers, configure a pair of
2.
logical tunnel interfaces to represent LT(x) and LT(y).
The solution uses logical tunnel (lt-) paired interfaces for stitching the Layer 2 and
Layer 3 domains.
A Layer 2 pseudowire terminates on one of the logical tunnel interfaces, LT(x),
defined with the circuit cross-connect (CCC) address family. A Layer 3 VPN
terminates the second logical tunnel interface, LT(y), defined with the IPv4 (inet)
address family. LT(x) and LT(y) are paired.
[edit interfaces]
user@PE1# set lt-1/2/0 unit 600 encapsulation vlan-ccc
user@PE1# set lt-1/2/0 unit 600 vlan-id 600
Copyright © 2017, Juniper Networks, Inc.