Enabling Inline Services Interface On Acx Series - Juniper ACX1000 Configuration Manual

Junos os; acx series universal access router
Hide thumbs Also See for ACX1000:
Table of Contents

Advertisement

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Enabling Inline Services Interface on ACX Series

1008
address or port are from a different source, you are free to assign a different external
address.
Network Address Translation Overview on page 999
Network Address Port Translation Overview on page 1001
Enabling Inline Services Interface on ACX Series on page 1008
Understanding Service Sets on page 1028
Service Filters in ACX Series on page 1035
Guidelines for Applying Service Filters on page 1036
Service Filter Match Conditions for IPv4 Traffic on page 1038
Service Filter Actions on page 1039
Network Address Translation Address Overload in ACX Series on page 1001
CoS for NAT Services on ACX Series Universal Access Routers on page 887
Network Address Translation Constraints on ACX on page 1003
Network Address Translation Rules Overview on page 1004
Configuring Service Sets for Network Address Translation on page 1030
Configuring Service Sets to Be Applied to Services Interfaces on page 1031
Configuring Queuing and Scheduling on Inline Services Interface on page 1040
The inline services interface is a virtual interface that resides on the Packet Forwarding
Engine. The
si-
interface makes it possible to provide NAT and IPsec services without
using a special services PIC.
To configure inline services interface, you define the service interface as type
(service-inline) interface. You must also reserve adequate bandwidth for the inline services
interface. This enables you to configure both interface or next-hop service sets used for
NAT and IPsec services.
NOTE:
In ACX Series routers, you can configure only one inline services
interface as an anchor interface for NAT and IPsec sessions: si-0/0/0.
To enable inline services interface:
Access an FPC-managed slot and the PIC where the interface is to be enabled.
1.
[edit chassis]
user@host# edit fpc slot-number pic number
si-
Copyright © 2017, Juniper Networks, Inc.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Acx5048Acx5096Acx500Acx1100Acx2000Acx2100 ... Show all

Table of Contents