Configuring Ldp Signaling On The Router - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
1248
You can include this statement at the following hierarchy levels:
[edit routing-instances routing-instance-name protocols vpls]
[edit logical-systems logical-system-name routing-instances routing-instance-name
protocols vpls]
NOTE: ACX Series routers do not support the
To configure the VPLS routing instance to use LDP signaling, you also must include the
statement to specify each of the neighboring PE routers that are a part of this
neighbor
VPLS domain:
neighbor neighbor-id;
You can include this statement at the following hierarchy levels:
[edit routing-instances routing-instance-name protocols vpls]
[edit logical-systems logical-system-name routing-instances routing-instance-name
protocols vpls]
NOTE: ACX Series routers do not support the

Configuring LDP Signaling on the Router

To enable LDP signaling, you need to configure LDP on each PE router participating in
the VPLS routing instance. A minimal configuration is to enable LDP on the loopback
interface, which includes the router identifier (
statement:
interface
interface interface-name;
You can include this statement at the following hierarchy levels:
[edit protocols ldp]
[edit logical-systems logical-system-name protocols ldp]
NOTE: ACX Series routers do not support the
You can enable LDP on all the interfaces on the router using the
statement. For more information about how to configure LDP, see the MPLS Applications
Feature Guide.
[edit logical-systems]
[edit logical-systems]
), on the PE router using the
router-id
[edit logical-systems]
all option for the
Copyright © 2017, Juniper Networks, Inc.
hierarchy.
hierarchy.
hierarchy.
interfaces