Juniper ACX1000 Configuration Manual page 1349

Incoming label: 299872, Outgoing label: 800002
Negotiated PW status TLV: No
Local interface: ge-2/0/6.0, Status: Up, Encapsulation: ETHERNET
Neighbor: 192.0.2.4
Interface
ge-2/0/6.0(vc 200)
user@PE3> show vpls connections
Layer-2 VPN connections:
Legend for connection status (St)
EI -- encapsulation invalid
EM -- encapsulation mismatch
VC-Dn -- Virtual circuit down
CM -- control-word mismatch
CN -- circuit not provisioned
OR -- out of range
OL -- no outgoing label
LD -- local site signaled down
RD -- remote site signaled down
LN -- local site not designated
RN -- remote site not designated RM -- remote site ID not minimum designated
XX -- unknown connection status
MM -- MTU mismatch
BK -- Backup connection
PF -- Profile parse failure
RS -- remote site standby
LB -- Local site not best-site
VM -- VLAN ID mismatch
Legend for interface status
Up -- operational
Dn -- down
Copyright © 2017, Juniper Networks, Inc.
Type St Time last up
rmt ST
On Router PE1 and Router PE2, use the
2.
the targeted LDP sessions have been created between the loopback interface to
the primary and backup H-VPLS hub neighbors.
user@PE1> show ldp neighbor
Address
10.10.3.2
10.10.1.2
192.0.2.3
192.0.2.4
10.10.9.2
user@PE2> show ldp neighbor
Address
10.10.3.1
10.10.5.2
10.10.4.1
192.0.2.3
192.0.2.4
On Router PE3 and Router PE4, use the
3.
that the VPLS connection status is
BGP-based VPLS Layer 2 circuits that are terminated.
NC -- interface encapsulation not CCC/TCC/VPLS
WE -- interface and instance encaps not same
NP -- interface hardware not present
-> -- only outbound connection is up
<- -- only inbound connection is up
Up -- operational
Dn -- down
CF -- call admission control failure
SC -- local and remote site ID collision
LM -- local site ID not minimum designated
IL -- no incoming label
MI -- Mesh-Group ID not available
ST -- Standby connection
PB -- Profile busy
SN -- Static Neighbor
RB -- Remote site not best-site
Chapter 35: Configuring Virtual Private LAN Service
# Up trans
show ldp neighbor
Interface Label space ID
ge-2/0/9.0 192.0.2.2:0
ge-2/0/10.0 192.0.2.3:0
lo0.0 192.0.2.3:0
lo0.0 192.0.2.4:0
ge-2/0/8.0 192.0.2.4:0
Interface Label space ID
ge-2/0/10.0 192.0.2.1:0
ge-2/0/9.0 192.0.2.4:0
ge-2/0/8.0 192.0.2.3:0
lo0.0 192.0.2.3:0
lo0.0 192.0.2.4:0
show vpls connections
for both the LDP-based VPLS and the
Up
command to verify that
Hold time
13
10
36
39
14
Hold time
12
11
11
39
38
command to verify
1291