Service Filter Actions - Juniper ACX1000 Configuration Manual

Service Filter Actions

Table 66: Terminating Actions for Service Filters
Terminating
Action Description
service Direct the packet to service processing.
Table 67: Nonterminating Actions for Service Filters
Nonterminating
Action Description
Accept the packet.
accept
Count the packet in the named counter.
count counter-name
Log the packet header information in a buffer within the Packet Forwarding Engine.
log
You can access this information by issuing the
command-line interface (CLI).
Port-mirror the packet based on the specified family.
port-mirror
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Chapter 31: Configuring Network Address Translation (NAT) and Stateful Firewall Services
Configuring Service Sets to Be Applied to Services Interfaces on page 1031
Configuring Queuing and Scheduling on Inline Services Interface on page 1040
ACX Series support different sets of terminating and nonterminating actions that you
can configure in a service filter term.
NOTE: Service filters do not support the
Table 66 on page 1039 describes the terminating actions you can configure in a service
filter term.
Table 67 on page 1039 describes the nonterminating actions you can configure in a service
filter term.
Enabling Inline Services Interface on ACX Series on page 1008
Understanding Service Sets on page 1028
Service Filters in ACX Series on page 1035
Guidelines for Applying Service Filters on page 1036
Service Filter Match Conditions for IPv4 Traffic on page 1038
Configuring Service Sets for Network Address Translation on page 1030
next term
command at the
show firewall log
action.
Protocol
Families
inet
Protocol
Families
inet
inet
inet
inet
1039