Configuring Load Balancing Based On Mac Addresses - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Configuring Load Balancing Based on MAC Addresses

798
the option at the
layer-3-only
hierarchy level:
[edit forwarding-options]
hash-key {
family mpls {
(label-1 | no-labels);
payload {
ip {
layer-3-only;
}
}
}
}
NOTE: You must also configure either the
the
[edit forwarding-options hash-key family mpls]
The hash key mechanism for load-balancing uses Layer 2 media access control (MAC)
information such as frame source and destination address. To load-balance traffic based
on Layer 2 MAC information, include the
[edit forwarding-options hash-key]
family multiservice {
destination-mac;
source-mac;
}
To include the destination-address MAC information in the hash key, include the
destination-mac option. To include the source-address MAC information in the hash key,
include the option.
source-mac
NOTE: Any packets that have the same source and destination address will
be sent over the same path.
NOTE: You can configure per-packet load balancing to optimize VPLS traffic
flows across multiple paths.
NOTE: Aggregated Ethernet member links will now use the physical MAC
address as the source MAC address in 802.3ah OAM packets.
NOTE: ACX Series routers do not support VPLS.
[edit forwarding-options family mpls hash-key payload ip]
label-1
family multiservice
hierarchy level:
Copyright © 2017, Juniper Networks, Inc.
or statement at
no-labels
hierarchy level.
statement at the