Starting And Stopping The Rfc 2544-Based Benchmarking Test; Copying An Rfc 2544-Based Benchmarking Test Result - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Starting and Stopping the RFC 2544-Based Benchmarking Test

Copying an RFC 2544-Based Benchmarking Test Result

1354
that matches the EtherType value set on the customer premises equipment (CPE)
to which your router connects. The EtherType value appears in the Ethernet type field
of the packet. It specifies the protocol being transported in the Ethernet frame. This
is an optional parameter.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set reflect-etype ethertype-value
Specify the reflection mode for the benchmarking test. This configuration is optional.
16.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set reflect-mode (mac-swap | no-mac-swap)
You can configure one of the following reflection modes:
—Enable rewriting of the MAC address on the reflected frames. The
mac-rewrite
MAC addresses specified in the
options are used.
mac-swap —Swaps the source and destination MAC addresses in the test frame.
This is the default behavior.
NOTE: In ACX5048 and ACX5096 routers,
in reflection mode.
no-mac-swap —Does not swap the source and destination MAC addresses in the
test frame. The frame is returned to the originator without any modification to the
MAC addresses.
To start an RFC 2544-based benchmarking test, issue the
rfc2544-benchmarking test test-name start
To stop an RFC 2544-based benchmarking test, issue the
rfc2544-benchmarking test test-name stop
To start an RFC 2544 benchmarking inet tests on Layer 3 VPN or virtual router, issue the
run test services rpm rfc2544-benchmarking test test-name routing-instance
routing-instance-name start
To stop an RFC 2544 benchmarking inet tests on Layer 3 VPN or virtual router, issue the
run test services rpm rfc2544-benchmarking test test-name routing-instance
routing-instance-name stop
You can copy the RFC 2544-based benchmarking test results to a local or a remote file.
To copy test results to a local file, use the
test-id number detail | save rfc-2544-test-result-session-id-number
source-mac-address
CLI command.
CLI command.
CLI command.
CLI command.
run show services rpm rfc2544-benchmarking
and
destination-mac-address
mac-swap is not supported
run test services rpm
run test services rpm
CLI command.
Copyright © 2017, Juniper Networks, Inc.