Configuring The Maintenance Domain Bridge Domain; Configuring The Maintenance Domain Mip Half Function; Configuring The Maintenance Association Intermediate Points With Bridge; Domain - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Configuring the Maintenance Domain Bridge Domain

Configuring the Maintenance Domain MIP Half Function

1130
MIP with with bridge domain
MIP with circuit cross-connect (CCC)
MIP with bridge domain when maintenance association end point is configured
MIP with CCC when maintenance association end point is configured
The following sections describe MIP configuration:
Configuring the Maintenance Domain Bridge Domain on page 1130
Configuring the Maintenance Domain MIP Half Function on page 1130

Configuring the Maintenance Association Intermediate Points with Bridge

Domain on page 1131

Configuring the Maintenance Association Intermediate Points with Circuit

Cross-Connect on page 1131
Configuring the Maintenance Association Intermediate Points with Bridge Domain
when Maintenance Association End Point is Configured on page 1131
Configuring the Maintenance Intermediate Points with Circuit Cross-Connect when
Maintenance Association End Point is Configured on page 1132
To configure the bridge domain, include the
ethernet connectivity-fault-management maintenance-domain maintenance-domain-name]
hierarchy level.
NOTE: The Layer 2 CLI configurations and show commands for ACX5048
and ACX5096 routers differ compared to other ACX Series routers. For more
information, see
and ACX5096 Routers" on page
MIP Half Function (MHF) divides MIP functionality into two unidirectional segments,
improves visibility with minimal configuration, and improves network coverage by
increasing the number of points that can be monitored. MHF extends monitoring capability
by responding to loopback and linktrace messages to help isolate faults.
Whenever a MIP is configured and a bridge domain is mapped to multiple maintenance
domains or maintenance associations, it is essential that the MIP half function value for
all maintenance domains and maintenance associations be the same. To configure the
MIP half function, include the
ethernet connectivity-fault-management maintenance-domain maintenance-domain-name]
hierarchy level.
statement at the
vlans
"Understanding Layer 2 Next Generation Mode on ACX5048
1167.
mip-half-function statement at the
[edit protocols oam
[edit protocols oam
Copyright © 2017, Juniper Networks, Inc.