Juniper ACX1000 Configuration Manual page 695

Copyright © 2017, Juniper Networks, Inc.
user@PE1# set lt-1/2/0 unit 600 peer-unit 601
user@PE1# set lt-1/2/0 unit 601 encapsulation vlan
user@PE1# set lt-1/2/0 unit 601 vlan-id 600
user@PE1# set lt-1/2/0 unit 601 peer-unit 600
user@PE1# set lt-1/2/0 unit 601 family inet filter input icmp_inet
user@PE1# set lt-1/2/0 unit 601 family inet filter output icmp_inet
(Optional) Associate a unique VRRP address with both Device PE1 and Device PE2.
3.
In this case, both Device PE1 and Device PE2 assume the mastership state for the
defined VIP IPv4 address, so no VRRP hello message are exchanged between the
routers.
[edit interfaces lt-1/2/0 unit 601 family inet address 10.41.0.101/24]
user@PE1# set vrrp-group 0 virtual-address 10.41.0.1
user@PE1# set vrrp-group 0 accept-data
Configure IS-IS or another IGP.
4.
[edit protocols isis]
user@PE1# set interface ge-0/1/1.0
user@PE1# set interface ge-0/1/2.0
user@PE1# set interface ge-0/1/3.0
user@PE1# set interface lo0.0
Configure the MPLS on the core-facing interfaces.
5.
[edit protocols mpls]
user@PE1# set interface ge-0/1/1.0
user@PE1# set interface ge-0/1/2.0
user@PE1# set interface ge-0/1/3.0
Configure label-switched paths to the other PE devices.
6.
BGP is a policy-driven protocol, so also configure and apply any needed routing
policies. For example, you might want to export static routes into BGP.
[edit protocols mpls]
user@PE1# set label-switched-path to_PE3 to 192.168.0.103
user@PE1# set label-switched-path to_PE2 to 192.168.0.102
Configure LDP on the core-facing interfaces and on the loopback interface.
7.
[edit protocols ldp]
user@PE1# set interface ge-0/1/1.0
user@PE1# set interface ge-0/1/2.0
user@PE1# set interface ge-0/1/3.0
user@PE1# set interface lo0.0
Configure RSVP on the core-facing interfaces and on the loopback interface.
8.
[edit protocols rsvp]
user@PE1# set interface ge-0/1/1.0
Chapter 20: Configuring MPLS and Pseudowires
637