Juniper ACX1000 Configuration Manual page 1577

Copyright © 2017, Juniper Networks, Inc.
—(M120, M320, MX Series, and T Series routers only) Include the first MPLS label
label-1
into the hash key. This is used for a one-label packet for per-flow load balancing IPv4
VPLS traffic based on IP information and MPLS labels.
label-2 —(M120, M320, MX Series, and T Series routers only) Include the second MPLS
label into the hash key. This is used for a two-label packet for per-flow load balancing
IPv4 VPLS traffic based on IP information and MPLS labels. To use the second MPLS
label in the hash key, include both the
forwarding-options hash-key family mpls]
hashing on the first and second labels. If both labels are specified, the entire first label
and the first 16 bits of the second label are hashed.
—(M120, M320, MX Series, and T Series routers only) Include the third MPLS
label-3
label into the hash key. To use the third MPLS label, include the
label-3 statements at the
level.
—Include no MPLS labels into the hash key.
no-labels
and
label-1 label-2
hierarchy level. By default, the router provides
[edit forwarding-options hash-key family mpls]
Chapter 41: Configuration Statements
statements at the
[edit
, , and
label-1 label-2
hierarchy
1519