Juniper ACX1000 Configuration Manual page 776

ACX Series Universal Access Router Configuration Guide
Meaning
Purpose
Action
718
bandwidth 10000000 priority - setup 4 hold 4 hops:
5 Mar 11 05:00:20.580 EXTCTRL_LSP: Control status became external
4 Mar 11 05:00:03.716 EXTCTRL_LSP: Control status became local
3 Mar 11 05:00:03.714 EXTCTRL LSP: Sent Path computation request and LSP
status
2 Mar 11 05:00:03.714 EXTCTRL_LSP: Computation request/lsp status contains:
bandwidth 10000000 priority - setup 4 hold 4 hops:
1 Mar 11 05:00:00.279 EXTCTRL LSP: Awaiting external controller connection
Created: Mon Mar 11 05:00:00 2013
Total 1 displayed, Up 1, Down 0
Egress LSP: 0 sessions
Total 0 displayed, Up 0, Down 0
Transit LSP: 0 sessions
Total 0 displayed, Up 0, Down 0
In the output, the
LSPtype
externally controlled. The output also shows a log of the PCEP messages sent between
Router PCC and the PCE.
The PCEP session between the PCE and Router PCC is up, and Router PCC receives the
following PCE-controlled LSP parameters:
ERO (path)—20.31.4.2 and 20.31.5.2
Bandwidth—8Mbps
Priorities—3 3 (setup and hold values)
Verifying the PCE-Controlled LSP Status When LSP Control Is Local
Verify the status of the PCE-controlled LSP from Router PCC to Router R2 when the LSP
control becomes local.
From operational mode, run the
user@PCC> show mpls lsp name PCC-to-R2 extensive
Ingress LSP: 1 sessions
10.255.179.98
From: 10.255.183.59, State: Up, ActiveRoute: 0, LSPname: PCC-to-R2
ActivePath: to-R2-path (primary)
LSPtype: Externally controlled, Penultimate hop popping
LSP Control Status: Locally controlled
LoadBalance: Random
Encoding type: Packet, Switching type: Packet, GPID: IPv4
*Primary to-R2-path
Priorities: 4 4 (ActualPriorities 3 3)
Bandwidth: 10Mbps (ActualBandwidth: 8Mbps)
SmartOptimizeTimer: 180
No computed ERO.
Received RRO (ProtectionFlag 1=Available 2=InUse 4=B/W 8=Node 10=SoftPreempt
20=Node-ID):
20.31.4.2 20.31.5.2
and output fields show that the LSP is
LSP Control Status
show mpls lsp name PCC-to-R2 extensive
State: Up
20.31.1.2 20.31.2.2
20.31.1.2 20.31.2.2
command.
Copyright © 2017, Juniper Networks, Inc.